Amana Tool 49550 Carbide Tipped Table Edge 1-3/4 Radius x 2-3/2 Dia x 5/8 x 1/2 Inch Shank fastening Must be used in a

Must be used in a table-mounted 3+ horsepower router and run at reduced speed

it shears down on both surfaces at the same time

Largest diameter bits should be run at reduced speed

The Roman ogee bit

The large gullet between the two flutes clears chips away quickly and the cutter geometry creates a crisp outline for a perfect fit

Amana Tool 49550 Carbide Tipped Table Edge 1-3/4 Radius x 2-3/2 Dia x 5/8 x 1/2 Inch Shank fastening Must be used in aCuts a shallow ogee into the tabletop surface coupled with a bead at the edge. Bit will produce a fillet if set to cut deep enough. With the optional 3 8" bearing, it will produce a fillet at the cut's edge. Good choice for handrails. These special router bits are used for cutting table top edges or used with handrail side profile bits. Originally designed for easing and profiling the edges of tabletops, these bits also are widely used for the same