Pay in 4 interest-free payments of $8.00 Learn more
Ships within 48 hours · Estimated delivery Sep 21 - Sep 26
I print this in PETG rather than PLA because the K17 runs warm under AI and multi-display loads
model A1842)
I 3D print this in PETG rather than PLA so it holds up to the heat an always-on router puts off without softening or sagging over time
The open lattice on the top and bottom lets the Ryzen chip breathe in a closed rack
with vents in the body to keep air moving over the metal case
10" Beelink EQ12 Mini PC Rack Mount - 1U 1st gen 2017 I print this in PETGThe Beelink EQ12 is a capable little N100 mini PC, but it usually ends up sliding around a desk or buried in a drawer. This mount gets it up into a 10 inch mini rack alongside your switch, patch panel, and the rest of your gear. Good for homelabs, edge networking, and small home servers where you want the PC mounted, ventilated, and out of the way. **Compatible with:** Beelink EQ12 (Intel N100). The EQ12 drops into the mount and the front panel keeps