Stasis Snare can be a good inclusion in certain situations but may not always be the best choice for competitive play
Whether you use it to shut down Aether Vial, Wasteland, or Jace, the Mind Sculptor, Pithing Needle found targets in a lot of matchups
Every week, but it's chaos
If you lose a Duel you are out of the tournament and you surrender your Secret Rare card to the winner, who must add that card to their Deck
When printing the bins, I used the following settings: 10% Infill (adaptive cubic) PLA Add these if you have issues with Warping: Supports on Build Plate Only Smooth Sheet When printing mine, I have done the following: 15% infill (a little less would probably be fine) PLA No brim, although it would be safe to add a brim Textured/Smooth steel sheet depending on desired finish Upside-down inserts to maximize surface contact (and to add a finish to the top) Horizontal dividers for a textured finish Happy printing
Three weeks later, a Pikachu Illustrator graded PSA 8.5 sold at Goldin for $727,120 (543,000 / 629,200) , a figure far from $16.5 million but consistent with a lower grade
